Kensapuu

Instructions for care


Stains and dirt can be wiped away gently using a moist cloth. If the stain does not come off with water, a cleaning agent can be added to the cloth. Spray cleaning agent to a clean cloth or moisten cloth in some other way. Wipe the surface clean and dry in the end if needed. No rinsing is required. Furniture doors can be cleaned using general household cleaning agents. Do not use boiling water for cleaning.

The use of abrasive or organic solutions is forbidden.

Doors can be damaged if in touch with very hot pieces, such as hot saucepans or frying pans.

Do not predispose doors to running water, for example when assembling products in humid spaces. (We recommend  Premium foiled doors in humid spaces.)

 

Heat Resistance of Premium Foiled Doors

Kensapuu's Premium foiled doors meet the quality demands set by SFS-,  and EN -standards as well as DIN -norms.

Heat resistance of Premium foiled doors is from -40ºC to +80ºC.  Momentary heat resistance is over 100ºC.

Premium foiled furniture doors can be installed in cold spaces, but not in spaces where temperature  drops  below -40ºC,

it is recommended that temprature of the oven is checked on the outside of frame when the oven is installed. If the temperature rises over the recommended limits, heat protection lists should be used. (EN-standard 60335-2-6: highest permitted temperature of metallic frame is 85ºC when the temperature in the oven is +200ºC for one hour.

 

Handling

No special requirements are needed for the storage of MDF -furniture doors. However, doors should not be exposed to water.

When handling doors, you must always be careful and cautious.

MDF -furniture doors are sensitive to dents especially their corners and edges.

When drilling holes for handles or hinges, check that your worktop is clean. Debris on the worktop can easily cause scratches to the surface of the door. Pay special attention when handling high gloss doors.

Premium foil high gloss doors have a thin protective foil attached to the surface which should be removed after installation.

Small wear and tear marks to the surface of painted doors  can be repaired with repair paint.  When the paint surface is damaged all the way down to MDF -board, the door is highly predisposed to moisture. In these cases, we recommend that the damaged door is replaced with a new door. Kensapuu Oy takes no responsibility of repairs carried out by others.

If the foil surface is damaged, it is not possible to mend it anymore. In these cases we recommend purchasing a new door.

 

Disposal

MDF -furnishing doors can be recycled. If destroyed, it should be done according to official instructions.

When burning foiled doors at  low temperature, the formation of hydrochloric acid is possible. This is why it is not recommended to burn foiled doors at home. Painted doors are not recommended to be burned at home either.

PVC-foil is classified as plastic waste.